Category: 

What Is Pitch Diameter?

In a screw, the pitch diameter, or thread pitch diameter, is found by measuring the tread's major and minor diameter.
The pitch of a gear basically measures the distance between the teeth.
Article Details
  • Written By: Jessica Reed
  • Edited By: Heather Bailey
  • Last Modified Date: 17 August 2014
  • Copyright Protected:
    2003-2014
    Conjecture Corporation
  • Print this Article
Free Widgets for your Site/Blog
Oprah Winfrey’s intended name was Orpah, but it was misspelled on her birth certificate.  more...

September 23 ,  1949 :  US President Harry S. Truman publicly announced the US had lost its monopoly on nuclear weapons.  more...

Pitch diameter is a term used to take measurements of the diameter of a gear or a screw using pitch points. Pitch points on a gear could be found if a straight line were drawn up from two of the gear's teeth located side by side and the two lines were connected by a curve. In the case of a gear or sprocket, pitch basically measures the distance between teeth. In the case of a screw, the pitch is shown by a straight line through the tread of the screw. Tread is the term for the spirals along the end of a screw that allow it to be inserted into a piece of wood and hold the screw in place.

In a screw, this measurement, which is often called the thread pitch diameter, falls in between the measurement of the tread's major and minor diameter. The major diameter is the measurement of the tread at its largest point — if a circle ran around the outside of the screw and skimmed along the outer edges of the tread, this would mark the major diameter. The minor diameter is also the measure of an imaginary circle, but this circle runs around the inner part of the tread where it stops turning and becomes the solid cylinder of the screw.

Ad

Gears, on the other hand, do not measure pitch diameter in the same way, though the concepts are similar. A gear (and a sproket) have both a pitch and an outer diameter. The outer diameter is the distance across an imaginary circle that goes around the outside of the gear. If a piece of string were placed around the gear along the top of the teeth and didn't dip into the gaps between teeth, this would be the outer diameter.

The pitch diameter, sometimes called the pitch circle diameter, for both gears and sprockets is measured as if a circle ran around the gear and passed through approximately the center of each tooth instead of across the top. To find the measurement more precisely, someone can imagine a circle in between each tooth on the gear that fills the gap and is roughly in line with the top of the gear's tooth. Measuring from the center of one of these circles to the center of the circle directly across from it is the pitch circle diameter.

Ad

More from Wisegeek

You might also Like

Discuss this Article

DylanB
Post 4

It sounds like gear pitch diameter is easier to measure than screw pitch diameter. However, I am mathematically challenged, so I hope I never have occasion to measure either one!

Perdido
Post 3

@feasting – Sure! Pitch diameter measurement is used to help people find the right screws for a certain job.

Pitch diameter is particularly useful if you are in need of replacement screws. Putting the wrong ones in could cause problems, so it's important to match them up with the old ones.

Some companies that sell screws have instructions on their websites for how to measure pitch diameter. They want to make sure that customers have access to information that will help them order the correct replacement screws.

feasting
Post 2

What is screw pitch diameter used for? Is there a need to know what the pitch diameter of a certain screw is?

anon145064
Post 1

Is there any equipment for measuring gear pitch?

And what is difference between one pitch tolerance and all pitch tolerances?

Post your comments

Post Anonymously

Login

username
password
forgot password?

Register

username
password
confirm
email