Category: 

What is Recrystallization?

Article Details
  • Written By: M.R. Anglin
  • Edited By: Kristen Osborne
  • Last Modified Date: 06 November 2016
  • Copyright Protected:
    2003-2016
    Conjecture Corporation
  • Print this Article
Free Widgets for your Site/Blog
Although they mainly functioned as downspouts, gargoyles were also intended to scare people into attending church.  more...

December 3 ,  1989 :  The Cold War officially ended.  more...

Recrystallization is a process that is used to purify a substance. It can be used in various processes, such as the creation of aspirin. This process is performed by placing the impure compound in a solvent, heating the solution so that the compound dissolves, and filtering the impurities. In some cases, it may be necessary to use carbon to remove colored contaminants from the compound. The mixture is then cooled, allowing pure crystals to form.

The main foundation behind recrystallization is the fact that substances will usually become more soluble when the solvent is hot than when it is cold. For example, sugar dissolves better in warm water than in cold water, which is why it is often difficult to dissolve sugar in iced tea even though a person may stir it thoroughly. The difference in solubility at varying temperatures allows an impure substance to dissolve at a higher temperature and then crystallize slowly at a lower temperature without re-trapping the impurities.

Ad

To purify a substance using this process, a person must start by choosing the appropriate solvent, sometimes through trial and error. The right solvent will not only dissolve the target compound at a higher temperature while allowing it to crystallize at room temperature, but also should not react with the compound. The solvent should also not dissolve the impurities at the same temperature as the target compound. Impurities should dissolve at room temperature while the compound is insoluble or should be insoluble at a higher temperature to allow the impurities to be filtered.

During the recrystallization, a person should only use a small amount of solvent to dissolve the target compound. If too much is used, the compound may not recrystallize when the time comes. When the target has been completely dissolved, any insoluble impurities can be filtered out. The solution should then be allowed to cool slowly so that crystals can form. If the solution is cooled too quickly, the crystals may trap dissolved impurities.

Should a white or clear compound be discolored when it is still in the hot solution, there may be colored impurities present. In such a case, activated carbon can be used to remove them. The carbon will attract the impurities and clear the solution, and then both substances can be filtered. Only a small amount of carbon should be used in this process because too much may start to react with the compound, reducing the final amount of the purified substance.

Ad

You might also Like

Recommended

Discuss this Article

Post your comments

Post Anonymously

Login

username
password
forgot password?

Register

username
password
confirm
email